Using Photogrammetric UAV Measurements as Support for Classical Topographical Measurements in Order to Obtain the Topographic Plan for Urban Areas

Elemer Emanuel SUBA, Tudor SĂLĂGEAN, Ioana POP, Florica MATEI, Jutka DEAK, Iulia COROIAN, Diana FICIOR

Abstract


This article aims to highlight the benefits of UAV photogrammetric measurements in addition to classical ones. It will also deal with the processing and integration of the point cloud, respectively the digital elevation model in topo-cadastral works. The main purpose of this paper is to compare the results obtained using the UAV photogrammetric measurements with the results obtained by classical methods. It will briefly present the classical measurements made with the total station. In the present project, the closed-circuit traverse and the supported on the endings traverse were made using known coordinate points. Determining the coordinates of the points used for the traverses was done by GNSS methods. The area on which the measurements were made is 67942m2 and is covered by 31 determined station points. From these points, 13 were used as ground control points, respectively components of the aero-triangulation network and 17 points were used to control the obtained results by comparing their coordinates obtained by classical methods with those obtained by the UAV photogrammetric method. It was intended that the constraint points of the aero triangulation to be uniformly distributed on the studied surface.

Keywords


photogrammetric measurements, point cloud, topographical plan, UAV

Full Text:

PDF


DOI: http://dx.doi.org/10.15835/buasvmcn-hort:0026


University of Agricultural Sciences and Veterinary Medicine
3-5 Manastur St., 400372 Cluj-Napoca
Romania
Tel: +40-264-596.384 | Fax: +40-264-593.792 
biroupublicatii@usamvcluj.ro